No one likes to keep up with greasing their axles, but it’s pretty much the only maintenance thing on a trailer. If you don’t, you run the risk of losing a wheel and/or tearing up the spindles on the axle (which means you have to replace the axle). Bearings should be re-greased every year or 3-5k miles, but taking them a part is a pain and grease is well…greasy. EZ lube axles are only so helpful. They let you use a grease gun ($35 at most online or in store) to insert grease to the back bearing, ONLY, hoping that some will make it up front. The issue though is the outer front bearing is the one most in need of grease from dirt that gets in from the dust cap. The grease seal on the back does a better job of keeping grease out, so EZ lube axles aren’t that helpful. Plus they have no indicator to tell you if you have over or under greased the bearing. That’s why stainless steel bearing protectors are far better than EZ lube axles. First, they do a better job than the cheap flimsy dust cap at keeping out dirt, debris and even water – not to mention they actually stay on! They have triple layers of protection versus the single layer of EZ lube axles. Second, and most importantly, they have a fail safe way of indicating when u need to re-grease, and they prevent you from over-greasing the spindle (red means add grease, green means good, and when it comes out the over-grease outlet you know it’s full and won’t let any other grease in to prevent failure). To me, it’s a must have on any trailer. Bearing protectors are $60 a pair.
A ‘tongue wrap’ increases the strength of the trailer as it ties the axle directly to the coupler hitch via the wrapped frame design. This means less swaying and bending in the frame of the trailer. It is absolutely necessary for any trailer above 16′ but great for 12′ and especially 14′ trailers. Here are some pictures of the difference between wrapped ($80) and unwrapped tongues:
An adjustable coupler is helpful for adjusting the trailer up and down and not having to have multiple hitches or an expensive adjustable hitch. It is heavier duty than the standard a-frame hitch. It also is the best way to keep your trailer from being stolen as you can simple remove it from the trailer. Similarly we can make chains removable as well. An adjustable coupler costs $60, and removable chains are $20.
Don’t want to carry around a jack with you every time you pull the trailer? That’s fine, just add a jack mount to the fenders and you can jack it up using your tongue jack (tandem trailers need front and back mounts). Fender jack mounts are $40/ pair.
Single axle trailers come with 16gauge smooth steel fenders for free. Options include jeep and heavier 14gauge fenders.
Tandem trailers come with 16gauge smooth steel fenders for free. Options include teardrop and heavier 14gauge fenders.
Tandem smooth teardrop fenders $60 (adds strength to middle of fender)
Sometimes you are pulling a car or ATV and need more room to load or more room to get a door open. Removable sides and/or fenders will help give you the extra space you need. Removable side/ fender is $160 and comes with a hinge and latches.
Drive-over fenders allow you to drive over the fenders on the trailer as well as integrate them with the width of the trailer so you CAN have more width up front, up to 98-102” (hammerhead design) and in the rear or just have more width to drive over and “cheat” side to side for wider vehicles – hammerhead options and wider trailers cost extra. Unfortunately, no manufacturers make these drive over fenders so they are all custom. These fenders allow the trailer to still sit low rather than going to a deckover trailer design where the axle is on top of the leaf springs rather than below them. We also offer a sort of half – drive over fender when you only need around a 90” hammerhead and not the full 98-102.
Single-axle or Tandem HALF drive-over fenders $240
If the trailer extensions aren’t your cup of tea, another options is the lay flat gate. The gate can be made
to lay flat forward for hauling longer pieces of metal or wood on your trailer off the back end. This
option comes with heavy duty latch pins for $100.